It is very important for concrete mixers to be maintained and maintained. Let's elaborate on this issue with our partners:
1. Regularly check the oil environment of each important assembly of the concrete mixer truck: the mobilization machine, transmission, brake system, power steering system, etc. It is generally possible to check by hand when refueling to see whether the oil of each tank is above or below. Between the two tick marks, if it is lower than the lower tick mark, it must be added in real time. The added engine oil must be the same type of engine oil used in the original model, so as to avoid the difference between the other engine oil (selection standard of the concrete mixer lubricant). Together, they cause chemical reverberation, which in turn makes the engine oil deteriorate and lose its dyeing. If the oil level drops quickly, it indicates that the system has leaks, and it is necessary to quickly check out the leaked parts and repair it in real time.
2, pay attention to the brake pads (two strokes to determine the concrete mixer brake pads need to change) and the clutch plate wear changes in real time: brake pads and clutch plates these two friction plates are depleting products, after a period of time will be loss, loss of the original With results, if it is not changed in real time, it can easily become a car accident. For serenity, it is best to install an electronic signal sensor. The brake indicator on the instrument panel will light up when about 1.5 mm of the friction plate remains. This reminds the driver (Concrete Mixer Truck Co., Ltd., a common knowledge of concrete mixers). Replace the friction plate. If in a rainy, wet weather, the friction plate will receive water, the friction will be significantly lower, the tanker will first lightly step on the brakes and clutches a few times, and the heat generated by the friction will evaporate the water on the friction plate. Then get out of the car.
3, four-wheel alignment is very important: use concrete mixer to bias the disk if the sentiment is different, they should go to the repair shop to do four-wheel positioning checks, and make the appropriate mediation. The appearance of the four wheels seems to be standing upright on the ground. It is not true. If you measure with an instrument, there is usually a deviation of 0.5 to 2 degrees. The naked eye does not look out. Don't look at the small 0.5 to 2 degree deviation. Selecting the steering function of the tanker will greatly reduce the maneuverability.
4, the maintenance of concrete mixer tires: often check the tire pressure, especially in the summer, high air pressure, easy to puncture, small tilt, shake head, then roll over; pressure is too low, increase resistance, corresponding increase in fuel consumption. Change the front and rear tires after the necessary mileage, because the weight of the two is not equal, and the wear is not equal. Before and after the tires change each other, the service life of the concrete mixer tires can be delayed and the cost of the vehicle can be saved.
Robot Pick-Up System,Ice Cream Manipulator,Robot Cone Pick-Up System,Ice Cream Pick-Up System
Wuxi Danxiao Machinery Co., LTD , https://www.wuxidanxiao.com