Subroutine programming method example.
The figure shows an example of turning not equidistant slots. It is relatively simple to use a cycle for isometric slots, and it is easier to call subroutines for slots that are not equally spaced.
It is known that the blank diameter is Φ32mm and the length is 77mm. The No. 1 knife is a round turning tool and the No. 3 knife is a cutting knife with a width of 2mm. The processing procedure is as follows
%0010
N001 G92 X150.0 Z100.0
N002 M03 S800 M08
N003 G00 X35.0 Z0
G95 F0.30 (feed to)
N004 G01 X0
N005 G00 X30.0 Z2.0
N006 G01 Z-55.0 F0.3
N007 G00 X150.0 Z100.0
N008 X32.0 Z0
T03
N009 M98 P15 L2
N010 G00 W-12.0
N011 G01 X0 F0.12
N012 G04P2.0
N013 G00 X150.0 Z100.0 M09
N014 M30
%0015
N101 G00 W-12.0
N102 G01 U-12.0 F0.15
N103 G04 X1.0
N104 G00 U12
N105 W-8
N106 G01 U-12 F0.15
N107 G04 X1.0
N108 G00 U12
N109 M99
Non Spring Trampoline,Springless Trampoline,Elastic Bungee Trampoline,Trampolines Without Springs
Jiangsu Baoxiang Sports Equipment Co., Ltd , https://www.skyboundsports.com