With the continuous improvement of people’s quality of life, the requirements for the environment have also increased a lot. Recently, many large cities have demonstrated the demand for multi-functional cleaning vehicles , and many brands have responded to the development of the times and developed many Different styles of multi-purpose cleaning vehicles .
The multi-purpose cleaning vehicle is actually a device used for cleaning dirt in the city's small advertisements. The high-end multi-function cleaning vehicle has some other uses. Now many large cities will choose this product to repair their own urban appearance because In the past, the kind of hand-cracking was too far behind. Moreover, many ink advertisements cannot be manually cleaned.
How is such a good product used? The steps of a vanity multifunctional cleaning car are mainly divided into five steps.
The first step is the lubrication process. The multi-purpose cleaning vehicle uses the No. 30 gasoline engine lubricant. There is a crankshaft pump on the multifunctional cleaning vehicle. We only need to add the lubricant to the red marked position. Pay attention to the position of the red point. More or less, there will be card cylinder or pump overheating. Then refuel the engine.
The second step is the startup process. In order to save time, many people start multi-purpose cleaning vehicles when they are lubricated. This is wrong. Must be added after the launch. The process of launch is actually very simple. It is to open the oil circuit switch, and then set the throttle to a state of speed, and finally start the key by inserting the key.
The third step is the connection process. This is a relatively simple step. It is only necessary to connect the filter and the inlet, the high pressure pipe, the high pressure gun and the sprinkler. It is important to remember the order and method of connection.
The fourth step is the boot process. Here we need to understand: Start is not equal to boot, start just to ensure that the machine can run, and boot is to enter the clean-up process. When you turn on the machine, you need to put the water inlet pipe in the water first, and then let the machine run. During the operation of the machine, we have to hold the handle of the gun until high-pressure water is sprayed out.
The fifth step is the shutdown process. The order of the shutdown process is very important, we must follow the steps, can not go wrong. First of all, we have to turn off the power, and then release the residual pressure by pulling the handle to remove the high-pressure barrel.
The above are the five steps for using the multifunctional cleaning vehicle. I believe that everyone has a clear understanding of the multifunctional cleaning vehicle. The operation method of the cleaning vehicle is still relatively simple, and the effect is very good. It is a real one. Help to improve the equipment in the city.
Yuyao Hongzhou Plastic Technology Co., Ltd. , https://www.hongzhoumould.com