Installation and layout of solar insect light
Solar insecticidal lamp is the main plant protection product of Zhejiang Top Instrument in 2014. Solar insect killer includes TPSC1-1, TPSC1-2 and TPSC1-3. Solar insecticidal lamps are widely used in agriculture, orchards, forestry, etc. Although widely used, they are not very clear about the installation of insecticidal lamps, wiring, hanging lights, etc. Today, we talk about a solar insect lamp. The installation layout and hanging lights.
1, the layout of the insect lamp
There are two ways to layout: First, the chessboard distribution, and second, the closed loop distribution. Generally in the actual installation process, chess patterns are more generally applicable. Because it is hanging in the field, it is convenient to maintain and maintain it by pulling the lights and then pulling the road to Daejeon. There are also users in the actual installation according to the actual situation using other distribution methods, which must be adapted to local conditions. No matter which method is used, the control area should be calculated with a single lamp radiation radius of 120m to achieve the purpose of energy-saving pest management.
3, wired
According to the type of lamp selected, choose a good 220V or 380V power supply, and then use a straight overhead line (the position of the line pole is best to match the layout of the lamp). Where there are no poles, wooden piles with a length of 2.5m or more are used as temporary poles. They must not be pulled anywhere to prevent accidents.
3, power requirements
The voltage fluctuation range of each lamp is within ±5% of the commercial power. If the voltage is too high or too low, the lamp will not work properly. If the power supply used is 220V, which is far from the transformer and the number of lights per line is more, in order to reduce power supply fluctuations, it is best to use three-phase four-wire or single-phase one-floor wire. The light in the line is evenly connected to each phase line so that the lamp can start normally. In addition, total road knife and branch knife should be installed in the line for hanging lights and maintenance.
4, hanging lights
Determine the location of the lamp, plant two wooden stakes or tripods, and use iron wire to fix the rings on the lamp to the crossarms of the two stakes. The height 31 is 1.3 to 1.5m (the distance from the ground to the insect population). To prevent the light from swinging back and forth when the wind blows, the lamp shell must be pulled on two piles with two wires, and then the wiring, the wiring port must be tightly wrapped with insulating tape. When the copper wire and aluminum wire are connected, pay special attention to prevent moisture. Oxidation, resulting in poor contact, so that the lamp does not work.
Hydraulic Busbar Cutting Punching Bending Machine
The multifunction busbar processing maching is the patented product developed by our company.Comparing with the traditional Busbar Processing Machine, this product has the following advantages and features:
The punching and shearing units adopt round integral structure, with novel and unique design rendering reasonable force bearing, and thus effectively guarantees the long-term use without deformation;
The bending unit uses integral structure and CNC angle control mode, allowing easy operation and high accuracy;
This machine adopts the design approach of double-layer work bench, truly realizing the simultaneous working of three stations without mutual interference;
The machine is provided with an automatic oil charge and discharge system, easy to operate, with the hydraulic oil charged into the oil tank via a filter so as to protect the entire hydraulic system from contamination;
This machine is provided with stainless steel oil tank to protect the hydraulic oil from corrosive deterioration, and extend the service life of hydraulic oil and the seals; PLC control that is stable and reliable.
Swappable dies offering extreme convenience;
PLC control that is stable and reliable.
Hydraulic Punching Machine,Hydraulic Busbar Cutting Punching Bending Machine,Cnc Busbar Punch Machine,Cnc Busbar Shear Machine
JINAN EURO-ASIA MACHINERY CO., LTD , https://www.euroasiamachine.com