1. The plane wave weight of cast iron weights Place the plane wave motion meter on the flat work surface, and move the plane wave motion instrument along any straight line. The moving distance is half the length of the diagonal of the plate and should not be less than 200 MM. Take the difference between the minimum and maximum values ​​of the plane fluctuation meter's indication table (division value is 0.001 MM). That is, the plane fluctuation of the work surface of the plate to be inspected.
2. The ratio of the contact area of ​​the cast iron weight will be coated with the display agent on the inclined plane of the inspection plater, and shall be studied on a flat plate whose accuracy level is not lower than that of the caster. The obvious contact point shall be displayed on the tested flat plate, and then a In the range of 50mm x 50mm, 400 small square transparent thin plates of 2.5mm x 2.5mm (such as organic glass plates) are scored. Place an arbitrary position on the work surface of the panel to be inspected, and observe in turn the ratio of the area occupied by the contact points in each square (in units of 1/10). Calculate the sum of the above proportions, dividing by 4 is the ratio of the contact area of ​​the detected part. For typical values. The ratio of contact area should be measured at another location and the average of the two results determined.
3. The cast iron weight deflection will place the detection device on the working surface of the inspected flat plate. When no load is applied, the torsion spring comparator probe is brought into contact with the working surface (for accurate measurement, the measuring head can be placed between the measuring head and the working surface. A thin piece) and make a note of the reading. Then apply force according to the rated load specified in Table 5 and write down the reading; the difference between the two readings is the deflection value of the working surface of the inspected flat plate under the rated load.
The bicycle was introduced in Europe in the 19th century and is still a very important means of transport today, and has been constantly changing, with more and more options in terms of appearance, function and material, such for convenient travel there are basic pedal Single Speed Bicycle, road bikes, electric bikes, for wilderness riding Sports Bike, there are mountain bikes(mtb bikes), snow bikes, for bicycle performance use there are Track Bicycle, bmx bikes and many more.
Our company mainly produced Single Speed Bikes, in order to the high strength and low weight, we adopted the aluminum alloy frame, that will lighter than steel frame and have very good rigidity and toughness at the same time.
The aluminum alloy frame and carbon fiber fork better suited to the flat road, potholed country road and bicycle race scene.
Single Speed Bicycle,Sports Bike,Track Bicycle,Single Speed Bikes
Suzhou Jingqiyao Intelligent Technology Co., Ltd. , https://www.jingqiyaoparts.com