Miniature submersible pump compact and lightweight, in rural areas play an important role in production and living, should pay attention to the following points in use.
A purchase submersible pump should pay attention to its model, flow and lift. If the specifications used inappropriately, will not be able to get enough water, can not play unit efficiency. In addition, we should also clarify the direction of rotation of the motor, some types of submersible pumps forward and reverse can be water, but the reversal of the small amount of water, the current is large, the reverse will damage the motor windings. To prevent submersible pump leakage in the water when working under the accident caused by electric shock, leakage protection switch should be installed.
Two. When installing a small submersible pump, the cable should be overhead, the power cord should not be too long. Do not force the cable when the unit is launching, which may cause the power cord to break. Submersible pumps do not sink into the mud, otherwise it will lead to bad heat and burn the motor windings.
Third, try to avoid starting at low pressure. When the voltage is too low, the motor speed will drop. If it is less than 70% of the rated speed, the centrifugal switch will be closed and the starting winding will be closed Power for a long time to heat or even burn the windings and capacitors. Do not switch the motor on and off frequently. This is because the pump will run back when it stops. If it is turned on immediately, the motor will start to load, causing the starting current to be too large to burn the winding.
Four. Do not allow the pump long-term overload operation, do not pumping large amounts of water, dehydration pump operation time should not be too long, so as not to overheat the motor and burned. During the operation of the unit, the operator must keep an eye on whether the working voltage and current are within the values ​​specified on the nameplate. If not, the motor should be stopped to find out the cause and solve the problem.
V. usually more than check the motor, found under the crack, rubber seal ring damage or failure, etc., should be promptly replaced or repaired to prevent water penetration into the machine.
BOPP Thermal Lamination Film is made by BOPP Film and EVA glue, it`s Bi-axially Oriented Polypropylene film with EVA coated. BOPP Thermal Laminated Film is used by extrusion coating process to combine the two layers. In the final film, one layer has BOPP properties and the other side becomes heat sensitive surface used for dry laminator. It has double side corona treatment. Both Glossy Thermal Lamination Film and Matte BOPP Thermal Lamination Film have excellent moisture barrier and clear transparency. The Thermal Lamination Film is widely used and plays an important part in packaging and printing industries.
BOPP Thermal Lamination Film,Glossy Thermal Lamination Film,Glossy BOPP Thermal Laminating Film,Matt BOPP Thermal Laminating Film
GR (SHANDONG) NEW MATERIAL CO., LTD , https://www.grmaterial-film.com