Tanker user manual and installation method

User operation

1. To ensure the tank truck is clean, the tank and oil system should be cleaned periodically. The inner and outer joints at both ends of the oil hose should be coated with lubricating oil. The tank truck can be easily disassembled and installed. After each time the tubing is completed, clean it in time to ensure that it is clean inside!

2. The use and maintenance of the tanker oil pump is strictly performed according to its use and maintenance instructions!

3, before refueling operations, must use the plug to insert moisture into the wet land, the tanker grounding tape should be grounded, the operation process should always maintain good static conduction!

4. Tanker safety valves and filter nets should always be checked and cleaned!

5, tanks and piping systems should be cleaned regularly. The tanker regularly checks whether the joints of the pipeline system are well connected and the seal is reliable!

6: The tanker should be installed in accordance with the provisions of the electrostatic belt, when the static electricity encountered in the car concentration of highly flammable gas, an explosion occurred, the electrostatic belt for the car body and other friction is frequent, easy to produce static electricity space can effectively go out Electrostatic hazards to ensure that the body is not compromised.

installation method:

Installed in the chassis metal parts! After a period of wear, the rubber band on the top can be put down!

Conditional users can install electrostatic tanker grounding alarm

Under the high-voltage wires, it is forbidden to add fuel to the tanker.

Never use the hanging fire method. Sometimes the spark plug of a car will have carbon deposition. When a certain cylinder's carbon deposition is serious, the cylinder will not work properly. In order to make the cylinder work normally, the method of “hanging fire” outside the cylinder is adopted (leaving the spark plug and the high voltage wire 3 Mm - 4 mm gap) to improve the energy of the spark plug electrode flashover, so that the cylinder back to work, but the general "hanging fire" method is not easy to fall off with little attention. If there is dripping gasoline on the cylinder, it is extremely easy to have a fire. Therefore it is only a temporary remedy. The correct treatment should be timely cleaning and maintenance of spark plugs, try to avoid the use of "hanging fire" method. Preparation of tanker before use

1. Insert the conductive rod into the ground to make it "grounded". If the ground is dry, it can be watered to make it wet, ensuring good grounding. Check the ground chain to make contact with the ground.

2. Open the tanker control box door and check the valve handles to make them closed (vertical position).

3. When using the oil pump for the first time, there is no oil in the pump and it is necessary to add oil in advance. 10 liters of oil can be added through the oil inlet.

4. Check the lubricant oil level in the gearbox to the lower edge of the grease plug hole. If insufficient, add gear oil.

5, check the gearbox lever, so that it is in a neutral position, check the position of the power lever control handle, so that it is horizontal to the right position, check the throttle controller to make it the smallest.


Glass Cleaner

In daily life, it is not uncommon for some friends to accidentally use Kitchen Cleaner or dishwashing detergent to mix and clean their own glass, resulting in poor cleaning or corrosion of the glass. After all, whether it is home glass or car glass, regular cleaning is always inevitable, and the necessity of using glass cleaner is rarely mentioned.

Glass cleaner is a type of cleaning product used to remove dirt, grime, and smudges from glass surfaces such as windows, mirrors, and glass tabletops. It typically contains a combination of solvents, surfactants, and ammonia or vinegar to dissolve and lift away dirt and stains. Some glass cleaners also contain anti-static agents to prevent dust and debris from sticking to the surface after cleaning. Glass cleaner can be purchased as a spray or a liquid concentrate that can be diluted with water.

Glass cleaner is used to clean the oil stain on the glass surface. Its main component is surfactant, slightly alkaline or neutral.
The cleaning product is scientifically formulated by surfactant, bactericide, essence and unique anti fog factor; It has good cleaning power, bactericidal power, antifogging, antifouling and no water marks, and is suitable for modern families, office buildings, hotels and entertainment places.


Glass Cleaner,Upvc Cleaner Spray,Car Glass Cleaning Spray,Screen Cleaner Spray

Jiangyin yinghuameng Houseware Co.,Ltd. , https://www.nbcare-guys.com